ZHDN 2500-150
14
Adjusting the chassis brackets
www.zepro.com
5
Adjusting the chassis brackets
The chassis brackets can be set to two different heights. This affects the distance between the
lift framework and the chassis (202 mm/242 mm). Take this into account when calculating the C
dimension. The brackets must also be fitted differently depending on the chassis width, see the
description below.
5.1
Adjustment
1. Undo the 8 bolts and nuts holding the two parts of the bracket together, see illustration
below.
2. Fit the two parts of the bracket in the correct position with the eight bolts and nuts.
If the chassis width is 1300 mm or more, fit the lower part to the inside (B) of the upper
part, see illustration below.
If the chassis is narrower than 1300 mm, fit the lower part to
the outside (A) of the upper part, see illustration below.
NOTE.
3. Tighten the bolts using a torque wrench.
Tightening torque: 180 Nm.
The parts must always be installed with eight screws – two in the front row of holes and
three each in the middle and rear rows of holes.
m
WARNING!
202 mm.
242 mm.
Position 1
Position 2
Image 11. Adjusting the chassis brackets
Chassis width
A
B
B
A
