ZHDN 2500-150
24
Installation
www.zepro.com
6.14
Platform
1. Check that all included components
are clean, cleaning them where
necessary.
2. Lubricate the metal bushings on the
upper bearing of the arms. Ensure
that the small holes on the inside of
the bushings are filled with grease.
See illustration. Use LE lubricant
4622 or the equivalent.
Carefully lubricate the metal bush-
ings on the upper bearing of the
arms. Ensure that the small holes
are filled with grease. After the
platform is fitted, lubricate all bear
-
ings via normal grease nipples,
see section "11 Lubrication and
fluid level check" on page 50
.
NOTE.
3. Fit the platform to the arms using
the supplied shafts and screws.
Tighten the bolts using a torque
wrench.
Tightening torque: 80
NOTE!
Lubricate the bushings
Nm.
4. Fit one of the tilt cylinders to the
platform. Use the supplied shaft as
a support wheel.
Make sure the cylinders are in-
stalled with the grease nipples
facing up.
NOTE.
Tighten the bolts using a torque
wrench.
Tightening torque: 80 Nm.
Image 32. Carefully lubricate the metal bushings
Image 33. Fitting the platform to the arms
Image 34. Fitting the tilt cylinder to the platform
