Z 2500-130/150
26
Installation
www.zepro.com
2x M12x100 8.8
80 Nm
2x M12x80 8.8
80 Nm
2x M12x80 8.8
80 Nm
2x M12x100 8.8
80 Nm
6.8
Underrun protection
6.8.1
Installation
Test the position of the underrun protection without
tightening the bolts to check that the statutory dimen-
sions are obtained. Adjust if necessary then tighten the
bolts with a torque wrench.
1. Fit the inner part of each bracket at one of four
heights. Select the height that meets the statu-
tory requirements, see section"6.8.2 Statutory
dimensions" on page 27. Use the correct bolts
M12x100. Assemble without tightening the bolts,
see Image 34.
2. Fit the outer part of each bracket at one of
five positions. Select a position that meets
the statutory requirements, see section
"6.8.2 Statutory dimensions" on page 27.
Check carefully that there is no risk of the outer
part of each bracket colliding with any part of
the cylinders when using the lift’s functions. In
particular, check in relation to the cylinders’ hose
connections, especially when the outer part of the
brackets is installed a long way in.
m
WARNING!
Use the correct bolts M12x80. Assemble without tight-
ening the bolts. See Image 37.
3. Check that the installation meets the statutory
requirements.
4. Tighten all the bolts using a torque wrench.
Tightening torque: 80 Nm.
5. Fit the beam end caps, rotated so the logo is the
right way up, and press them firmly to secure. If
necessary, tap carefully with a rubber hammer.
Image 34. The inner part of the brack-
ets can be fitted at one of four heights
Image 35. The outer part of the brack-
ets can be fitted in one of five positions
Image 36. Fit the beam end caps
Image 37. Installing underrun protection
133
193
241
301
617
667
717
767
817
Summary of Contents for Z 2500-130 DA
Page 2: ......
Page 77: ...Z 2500 130 150 Specifications 77 www zepro com Image 92 Loading diagram 18 4 Loading diagram...
Page 79: ......
