Zepro Z 2500-130 DA, Installation Instructions Manual

Page: 72 / 80

Z 2500-130/150
72
Testing and verification
www.zepro.com
16 Testing and verification
Testing and verification of the tail lift takes place in accordance with the installation/delivery inspection. Verify
that the tail lift is suitable for the vehicle in question and for the intended use.
16.1 Static load test
16.1.1 Deformation
Position the tail lift half way up to the vehicle floor level and with the platform in the horizontal position. Measure
dimensions A-B-C-D for comparison as illustrated.
Place a test load on the platform according to the table for the respective tail lift model and lifting capacity.
Remove the test load from the platform.
Repeat the measurement of A-B-C-D and verify that there has been no deformation of the lift or its fixing.
16.1.2 Drift
Place a test load on the platform according to the table. The tail lift must be at the same level and angle as the
vehicle floor. Leave the test load for 15 minutes.
Verify that the platform drift is no more than 15 mm on the vertical (points A and D) and 2º in terms of the angle.
1.1.1 Static load (Test load 1.25 x tail lift loading capacity). For tail lifts with load centre of 1000
mm
Capacity Load 1500 kg Load 2000
kg
Distance out in platform (L)
2500 kg 2120 mm 1560 mm
Image 90. Testing and verification
Max 2º
Max. 15 mm
B
D
C
A
B
D
C
A
Vehicle floor level
Deformation
Drift