Z 10/15/20
Testing and verification
47
www.zepro.com
11
Testing and verification
Testing and verification of the tail lift takes place in accordance with the installation/delivery inspection. Verify
that the tail lift is suitable for the vehicle in question and for the intended use.
11.1 Static load test
11.1.1 Deformation
•
Position the tail lift half way up to the vehicle floor level and with the platform in the horizontal position.
Measure dimensions A-B-C-D for comparison as illustrated in Image 68.
• Place a test load on the platform according to the table (for the respective tail lift model/lifting capacity).
• Remove the test load from the platform.
•
Repeat the measurement of A-B-C-D and verify that there has been no deformation of the lift or its fixing.
11.1.2 Drift
• Place a test load on the platform according to the table. The tail lift must be at the same level and angle
as the vehicle floor. Leave the test load for 15 minutes.
• Verify that the platform does not drift more than 15 mm on the vertical (points A and D) and no more than
2º in terms of the angle (points B and C) in relation to the floor.
Summary of Contents for Z 10
Page 2: ......