Z 10/15/20
Installation
27
www.zepro.com
2x M12x100 8.8
80 Nm
2x M12x80 8.8
80 Nm
2x M12x80 8.8
80 Nm
2x M12x100 8.8
80 Nm
6.7.3 Installation
Test the position of the underrun protection without
tightening the bolts to check that the statutory
dimensions are obtained. Adjust if necessary and
then tighten the bolts with a torque wrench.
1. Fit the inner part of each bracket at one of
four heights. Select the height that meets the
statutory requirements, see section "6.7.2
Statutory dimensions for underrun protection" on
page 25. Use the associated bolts M12x100.
Assemble without tightening the bolts, see Image
36.
2.
Fit the outer part of each bracket at one of five
positions. Select a position that meets the statu-
tory requirements, see section "6.7.2 Statutory
dimensions for underrun protection" on page 25.
Check carefully that there is no risk of the outer
part of each bracket colliding with any part of the
cylinders when using the lift’s functions. In particu
-
lar, check in relation to the cylinders’ hose con
-
nections, especially when the outer parts of the
brackets are installed a long way in.
WARNING!
Use the associated bolts M12x80. Assemble without
tightening the bolts. See Image 37.
3. Check that the installation meets the statutory
requirements.
4. Tighten all the bolts using a torque wrench.
Tightening torque: 80 Nm.
5. Fit the beam end caps rotated so the logo is the
right way up, and press them firmly to secure. If
necessary, tap carefully with a rubber hammer.
Image 36. The inner part of the brack-
ets can be fitted at one of four heights
Image 37. The outer part of the brackets
can be fitted in one of five positions
Image 38. Fit the beam end caps
Image 39. Installing underrun protection
133
193
241
301
617
667
717
767
817
Summary of Contents for Z 10
Page 2: ......