Z 10/15/20
32
Installation
www.zepro.com
The tilt angle must be set at 90° to the vehicle
body before the downward tilt angle is adjusted
(see previous page).
NOTE.
To ensure that the lift is safe and CE compliant,
the downward tilt angle must be adjusted to max.
10° if persons are going to stand on the platform.
WARNING!
Do not adjust the tilting cylinders before undoing
the lock screws.
NOTE.
1.
Lift the platform to floor level and adjust to hori
-
zontal position.
2. Tilt down the platform and measure the angle
(pos. 5, Image 51). Adjust to max 10º.
3. Loosen the end stop lock screw (1, 2). Screw the
end stop all the way back towards the platform
(3). Image 50.
4. Tilt the platform down to max. 10 degrees below
the horizontal, see Image 52.
5. Tighten the lock screw in the end stop (5). See
Image 51. Zepro recommends securing the
screws with Loctite 243 or equivalent.
Test all functions.
6.11.2 Adjusting the downward tilt angle
Image 50. End stop with lock screw
Image 51. End stop with lock screw
Image 52. The downward tilt an-
gle must be adjusted to max. 10°
Summary of Contents for Z 10
Page 2: ......