Z 10/15/20
18
Installation
www.zepro.com
16. Bolt the brackets securely on the outside of the
vehicle chassis. Install in the slot-shaped holes
with at least 6 screws. Use suitable bolts (dura-
bility equivalent to M14 10.9 or higher) and install
the associated washer and nut on the inside of
the vehicle chassis. Install the bolts but do not
tighten. See Image 18.
17.
Check and perform fine adjustment regarding the
position of the lift. Then tighten the bolts with a
torque wrench.
Tightening torque: Standard for
selected screw.
18. Using a torque wrench, tighten the bolts holding
the U-profiles.
Tightening torque: 280 Nm.
19. Drill holes in the vehicle chassis for mounting
bolts in each bracket’s two upper round holes.
Use suitable bolts (durability equivalent to M14
10.9 or higher) and install the associated washer
and nut on the inside of the vehicle chassis.
See Image 18. Tighten the bolts with a torque
wrench.
Tightening torque: Standard for se-
lected screw.
20. Remove the mounting jig.
Welding is not permitted on the chassis brackets.
Do not move the lift all the way to the armstops
or with the platform fitted before all the bolts are
fully tightened against the chassis.
Do not place the lift under load until:
· the correct number of bolts have been in-
stalled and torque-tightened.
· the vehicle body is installed to reinforce the
truck chassis.
NOTE.
Image 18. Installing the chassis bracket on
vehicle chassis with pre-drilled holes
When installing on chassis with pre-drilled holes
Summary of Contents for Z 10
Page 2: ......