46
3. Dry fit the rest of the cabinet. Place the FRONT, BACK and two SENSOR MOUNTS in place.
Notice the SENSOR MOUNTs have two little divots in one face for holding magnets. This faces
up. Concentrate on achieving a nice tight joint where the parts all come together. Do not worry
about how well the top surfaces align; they will be completely hidden by the LID (7). You may
get a better-looking joint when you install the front while it rests against the plywood work
surface, or it might look better when it hangs over the edge.
6
7
4. Attach the FRONT and BACK:
a. When you have decided on the best way to attach the FRONT, apply glue to the insides
of the notches on the ENDs as shown (8a). Remember the front side of the BOTTOM is the
edge with the holes farther in.
b. Peel back some of the paper from the edges of the FRONT and attach it to your cabinet.
Hold until the glue sets (8b).
c. Run a tiny bead of glue along the cabinet interior where the FRONT meets the BOTTOM.
Gently press the parts together until the glue sets.
d. Repeat for the BACK (9a,9b). Let the cabinet sit for a good while until the glue is cured.
8a
8b
9a
9b
