39
g. Remove the binder clips; remove the last of the backing (32); stick the label onto the cabinet
(33). If your card stock has a textured surface, you may need to warm the sticker with a hair
dryer and burnish it down thoroughly.
32
33
12. Cut out the label holes.
a. Cutting through the label and down into the cabinet, cut out the seven pot holes and the LED
hole. Completely remove the black dots, leaving the white rings (34). Alternatively, you could
use a 1/4” round hole punch, but you will have to be very precise since the punched holes
will not be much larger than the pot shafts.
b. Cut out the window for the LED display (35), cutting along the inner edge of the white line.
34
35
13. Crease the Folds:
a. Crease along each scored fold line, one by one, until each fold more or less stands up at 90
degrees on its own (39), except Tabs G; these bend up 45 degrees only (36,37).
36
37
