23
e. Install the AtMega328p microcontroller in its socket. If the pins don’t line up too well to the
socket, you may have to gently bend the leads a little closer together by pushing each side
of the chip down on a flat surface (56). Once the pins line up to the socket holes, push the
IC snugly into place (58,59).
56
57
58
59
10. Voltage Regulator (U5): This component is shaped like a three-quarter moon and looks very
similar to the transistors you installed earlier. Thread the three leads through the PCB and press
this component into place (60). Bend the leads out on the other side of the board. Solder and
clip the leads.
60
61
