25
b. Solder the pots. When soldering do not use too much heat. If you cannot move quickly with
your iron, solder one pin on each pot sequentially. This will allow each pot to cool before
you solder its next leg (67). Make sure all 5 pins of each pot are soldered. Don’t bother
clipping the short leads.
68
69
13. DC Power Jack (P1): Press it snug to the board. Double check that it is sitting flush and square to
the edge of the board (70). Solder the pins on the solder side. (71).
70
71
14. Power Switch (S1): Push the little red button (part #SW-60-22) onto the switch (72). If the button
seems a little loose, add a tiny drop of super glue to the switch shaft before installing the button.
Press the switch snug to the board (73) and solder the leads (74-75).
72
73
74
75
