Zenith Z-100 Series, User Manual

Page: 49 / 150

Page 48
WINCHESTER SUPPLEMENT
Booting from the Winchester
NOTE: This boot procedure assumes that you have assigned
a CP/M partition as the default boot partition. If you have not
assigned any partition as the default boot partition, read the
section entitled, "Booting from the Winchester — No Default
Boot Partition."
At this point, you may boot your Computer from the Winches-
ter disk. Use the same procedure to boot your Computer as
you would if you were using a floppy disk. The only difference
is that the Winchester cannot be removed from the system
and so it is ready to go when you turn on or reset your Com-
puter.
If your Computer is not set up to boot from the Winchester
disk, you will have to press the ~I~
key to s t op any auto
boot process and then press the [g key and then the [g key,
f ollowed by the ~ ~
@] key. The Winchester LED disk ac-
e~-.s indicator will light and in a moment, the CP/M-85 initial
,messages will appear, along with the CP/M prompt. You have
booted your system from the Winchester and may now use
any CP/M-85 compatible program or utility of your choosing.
Booting from the Winchester — No Default
Boot Partition
If you have not established a default boot partition, you may
boot from any partition by following this sequence of opera-
tions:
Press the [g key and the [g key in sequence.
Type a colon (:) and the name of the partition that you
wish to boot the computer from, and then press the RE-
TURN key.