Zenith Z-100 Series, User Manual

Page: 38 / 150

page 37
WINCHESTER SUPPLEMENT
The PARl U t i lity
your disk, you will not be able to complete the operation until
you have entered a value that is equal to or greater than
the minimum figure. While entering the new figure, you will
see several things happen.
• Th e o ld percent figure will be erased when you press the
first number of the new figure.
• Th e ~ g g g g ~ key w ill operate normally, moving one
character to the left and erasing the character under the
cursor. But, when you use the
Qggg g~~
to erase
the first number entered, the amount will remain blank (un-
like the partition and operating system names which reap-
pear). If you press the ~ g g key a t that point, the
• If you press only the ggggg k e y, the value will remain
unchanged while the cursor moves to the next row's parti-
tion name (if you are currently working on one of the first
15 partitions) or the default boot partition area (if you are
currently working on the 16th partition).
If you do not want to make a change to the current figure,
do not make any entries; press the ggggg] key.
If you wish to alter the value, type the new value and
press the g~gg key.
Once you press ~ ~ , the c u rsor will move to the partition
name position for the next partition, unless you have just
finished with the last (16th) partition in the table, in which
case the cursor will move down to the default boot partition
entry position.
NOTE: If you have two partitions with identical names, and
one is the default boot partition, PART will always select the
partition with the lowest partition number in the table as the
default boot partition (even if the highest partition number was
old value will be restored when the screen is redrawn.