51
GW29-034_v01
INSTALLATION
1. Make sure all wrappings have been removed from the inside of the oven.
2. Remove any protective
fi
lm from the housing of the microwave oven.
WARNING: Do not remove the light brown Mica cover which pro-
tects the magnetron.
WARNING: Check for damage such as a door that is not lined up
correctly, damage to door seals and sealing surfaces, broken or
loosened hinges or latches, dents inside the oven or on the door.
3. In case of any damage do not operate the appliance and contact
the quali
fi
ed service personnel.
4. Place the microwave oven on an even and stable surface that is
strong enough to hold the oven and the heaviest foods you put in it.
5. Do not expose the microwave oven to high temperatures and humid-
ity. Do not place the oven near
fl
ammable materials as well as appli-
ances generating heat.
6. Do not cover or block the ventilation openings. Do not remove the legs.
7. Do not operate without the glass tray and the turntable ring assembly
properly installed.
8. Make sure the cord is not damaged, is not placed under the oven or
above any hot or sharp surface and does not hang over the table or
counter.
9. Ensure an easy access to the outlet so that it is possible to easily
unplug the appliance in case of emergency.
10. Do not use and store the oven outdoors.
THE WALL UNIT BUILD UP
1. The cupboard for building in cannot have a back wall behind the ap-
pliance.
2. The minimum installation height is 85 cm.
3. Do not cover the ventilation openings and air outlets.
MICROWAVE OVEN INSTALLATION
1. Install the oven in the cupboard:
• Adjust the height of the A adjustment screw to receive a 1 mm slot
between the A adjustment screw and the upper cupboard surface.
• Never clench or entangle the cable.
2. Open the door, and
fi
x the oven to the cupboard next to the installa-
tion opening in the opening clamp using the C screw.
GROUNDING INSTRUCTIONS
The appliance must be grounded. The oven is equipped with a cord having
a grounding wire with a grounding plug.
The plug must be plugged into an outlet that is properly installed and
grounded.
In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric current.
The oven should be used in a separate electric circuit.
If an extension cord is used:
1. The extension cord must be a grounding-type 3-wire cord.
2. Arrange the extension cord so that it is placed away from hot and
sharp surfaces and cannot be accidentally pulled or tripped over.
WARNING: Improper plugging can result in the risk of an electric
shock.
Notice:
In case of any doubts concerning the grounding or plugging in-
structions contact a quali
fi
ed electrician or serviceman.
WARNING: Both the manufacturer and the seller do not accept any
liability for any oven damages or injuries resulting from not following
the plugging instructions.
RADIO INTERFERENCE
Operating the microwave oven may cause interference to the radio, TV or
similar equipment.
Interference can be reduced or removed in the following way:
1. Clean the door and sealing surfaces of the oven.
2. Adjust the receiving antenna of the radio and television.
3. Move the microwave oven so that it changes its position towards the
receiver.
4. Move the microwave oven away from the receiver.
5. Plug the microwave oven into a different outlet so that the microwave
oven and the receiver are on different branch circuits.
Height adjustment
A screw
adjustment
Opening clamp
Screw C
Installation
opening
Summary of Contents for ZKM2021EB
Page 33: ...33 GW29 034_v01 C 18 19 20 21 22 23 24 c 25 1 2 3 4 5 6 7 8 9 10 1 2 M 85 c 3 1 A 1 2 O C 1 2...
Page 39: ...39 GW29 034_v01 17 18 19 20 21 22 23 24 25 1 2 3 4 5 6 7 8 9 10 1 2 85 3 1 1 2 1 2 C...
Page 45: ...45 GW29 034_v01 17 18 19 20 21 22 23 24 25 1 2 3 4 5 7 8 9 10 11 1 2 85 3 1 A 1 A 2 C 1 2 C...
Page 56: ...GW29 034_v01...
