10
The juice squeezer can be applied as an additional equipment for Zelmer
mincing machines. It allows to squeeze juice from fruits such as: raspberries,
currants, strawberries, gooseberry and additionally from grapes and tomato
-
es. Berry fruits such as currants can be squeezed with stalks. Fruits with lar
-
ge stones for example plums, cherries etc can be squeezed in the appliance
after removing the stones.
Appliance elements:
1. Chamber
2. Worm
3. Body
4. Nut
5. Juice channel
6. Adjusting screw
7. Bowl
8. Pusher
9. Screen – 2 pieces
No. 1 – smaller openings
No. 2 – larger openings
10. Large sealing ring for the body
(3)
11. Small sealing ring for the worm
(2)
NOTE: Use only the pusher to push fruits (8).
Preparing for operation and operation
Make sure the sealing rings
–
(10)
and
(11)
are installed on the
body
(3)
and worm
(2)
. If not, please install the sealing rings in
the openings of these elements (the body and the worm).
Insert the screen
–
(9)
into the body
(3)
and push until stop.
Insert the worm
–
(2)
into the squeezer chamber
(1)
and insert the
body with the screen onto the worm paying attention that the
sieve is placed downwards, and the positioning opening fits the
protrusion of the squeezer chamber.
Screw the nut
–
(4)
onto the squeezer chamber
(1)
.
Screw the adjustment screw
–
(6)
into the body
(3)
and insert the
juice channel
(5)
until it snaps shut on the body
(3)
and you hear
a click.
click
GB
JUICE SQUEEZER
Insert the assembled squeezer onto the motor, proceeding in the same way as in the description of the
–
mincing chamber.
Insert the bowl
–
(7)
and the pusher
(8)
.
Put some appropriate vessels for juice and pulp under the juice channel outlet
–
(5)
and adjusting screw
(6)
.
Plug in the appliance.
–
Turn on the appliance by pressing the
–
„I”
button and next insert the fruits pushing them with the pusher.
In order for the juice squeezing process to run properly do not screw the adjustment screw too deeply in
the initial operation phase. After assessing the amount of juice in the processed fruits, adjust the screw
in order to obtain an adequate effectiveness and to avoid clogging the appliance.
Observe the pulp dryness during squeezing. If they are too dry, unscrew the adjusting screw
–
(6)
, to avo
-
id clogging the appliance.
The screw adjustment depends on the type of processed fruits, in case of juicy and ripe fruits adjust the
screw deeper, and for fruits that are not as juicy, the level of screw adjustment should be lower.
If the screw adjustment does not provide an adequate squeezing effectiveness, you can process the
processed fruits once again.
The clogging of the chamber outlet (in the adjustment screw
(3)
) with juicy processed fruits can cause
the juice to contact the motor.
Unplug the appliance if the chamber outlet becomes clogged. Pay special attention during the juice
squeezing process, make sure the screen openings are not clogged. Dismantle the juicer from the motor
(as in the case of the mincing chamber), dismantle the squeezer, clean (wash) the squeezer elements.
Use the included brush to clean the appliance, especially the screen.
the protrusion of the
casing has to fit the
body groove
Summary of Contents for 986.9000
Page 11: ......
Page 12: ...986 003...
