Zeiss MMZ M, Operating Instructions Manual

Page: 120 / 154

Errors occurring prior to the measuring operation
8-2
61211-1270302 MMZ M
Errors occurring prior to the measuring operation
If the CMM cannot be started, check whether the following errors can
be excluded:
Errors Cause Measure Check
The CMM can-
not be started. Wrong start-up se-
quence. – Follow the specified order.
– First, switch on the CMM and
then the computer.
Power Supply The main switch is
not on.
Connect power supply:
– Turn the main switch to the «1»
position.
Position «1» must be
visible.
Controller The controller is off. Switch the control unit on:
– Turn the rotary switch clock-
wise.
The indicator lamp in
the rotary switch
must be lit.
Drives The drives are off. Switch on the drives:
– Push the button on the con-
troller cabinet.
There is a button on the BP26SE
control console to turn on the
drives.
The indicator lamp of
the button must light
up.
In the BP26SE control
console, the LED
above the button is
lit.
The EMERGENCY
STOP button on the
control console is
locked.
Unlock the button:
– Slightly turn the EMERGENCY
STOP button .
The button pops out
a few millimeters.
The EMERGENCY
STOP button on the
control console is
locked.
Unlock the button:
– Slightly turn the EMERGENCY
STOP button .
The button pops out
a few millimeters.
Pressure The compressed air
line is defective. – Check the compressed air line
and the connections. Pressure gauges
The compressed air
line is not connected. – Connect the compressed air
line.
1 If the above mentioned errors can be excluded, put the CMM out of
operation and repeat the start-up procedure.
2 If measuring operation is still not possible, call a ZEISS service engi-
neer or our support team.
➤
See [
⇨
8-8]