Zeiss AT 030, Product Documentation Set

Page: 22 / 88

4 Installation Instruction for use
AT 030 4.3 Mounting the device on SL 800 slit lamp using the swivel-mounted tonometer
holder on the stereomicroscope or Fundus VarioView
16 / 60 319300-9120-000-GA-GB-240320
4.3 Mounting the device on SL 800 slit lamp using
the swivel-mounted tonometer holder on the
stereomicroscope or Fundus VarioView
NOTE
Damage due to improper assembly
u
After assembly, make sure the device and tonometer holder are
firmly seated.
Action 1. Position the tonometer holder with the guide pins on the
stereomicroscope or, if mounted, on the Fundus VarioView
such that the mounting pivot points to the headrest
2. Attach the mounted tonometer holder using the size 3 screw-
driver, supplied.
3. Attach the device to the base plate of the tonometer holder
and fix it by means of the knurled screw.
4. Ensure that the centering pin is securely seated into one of the
two alignment holes. Select the alignment hole on the side
where the eyepiece is to be used. If the tonometer holder is
adjusted correctly the measuring prism will be visible in the
center of the eyepiece.
HINT: The applanation tonometer with the base plate of the swivel-
mounted tonometer holder can easily be swung out of the optical
path by turning it laterally to the right around its vertical axis A.
This enables unhindered work with the slit lamp. Additionally, the
extensible measuring prism holder can be pushed into the
tonometer. The measuring prism holder should then be in its
bottom end position.