Z-World EG2110, User Manual

Page: 11 / 50

User’s Manual 7
2. G
ETTING
S
TARTED
This chapter shows how to make the necessary hardware connections and how to configure the
network parameters for the RabbitLink.
2.1 RabbitLink Physical Connections
1.
Attach the RabbitLink board to the plastic enclosure base.
Position the RabbitLink board over the plastic enclosure base as shown below in Figure 2.1.0-
1. Attach the RabbitLink board to the base at the top left and bottom right positions using the
two 4-40 × ¼ screws supplied.
Figure 2.1.0-1 Attach RabbitLink Board to Plastic Enclosure Base
The plastic enclosure base facilitates handling the RabbitLink during development. It is avail-
able in the RabbitLink Tool Kit.
NOTE: Appendix B, “Plastic Enclosure,” provides additional information and
specifications for the plastic enclosure.
Flash EPROM
Flash EPROM
90
15
65
SRAM