Z-World EG2110, User Manual

Page: 38 / 50

34 RabbitLink (EG2110)
set netmask x.x.x.x
This command sets the netmask.
x.x.x.x
This is the dotted decimal format of the netmask. The factory default is
255.255.255.0
.
set passphrase
This command will prompt for a passphrase twice to confirm that the passphrase was cor-
rectly entered. The characters are not echoed back as a security measure. As another security
measure, the passphrase is hashed before it is stored on the RabbitLink. Whenever a new
session starts with Dynamic C or the RFU, the user will be asked for the passphrase. It
should be as long as possible to increase security, up to the maximum length of 255 charac-
ters.
set port x
This command sets the TCP port number. If the RabbitLink is being used behind a firewall,
it may be necessary to punch a hole in the firewall to allow remote access.
x The port number. The factory default is 4244.
set dhcp <on | off>
This command enables and disables the use of any DHCP server that is available on the net-
work. The default condition is
on . This command is only available with RabbitLink serial
console version 2.00 and later.