Z-World EG2110, User Manual

Page: 28 / 50

24 RabbitLink (EG2110)
2. Install light pipes (optional).
Light pipes are included in the tool kit so you can see the LEDs on the RabbitLink board once
the enclosure is assembled.
Figure B.1-2 Install Light Pipes in Enclosure Top
With the enclosure top positioned as shown in Figure B.1-2, insert three light pipes into the
slots identified in Figure B.1-2. Position the light pipes snugly against the enclosure top since
there is little clearance between the light pipes and the LEDs on the RabbitLink board. The
light pipes snap in place. Verify that the light pipes are aligned over the LEDs, then apply a
drop of cyanoacrylate or contact cement to the inside of the enclosure around each light pipe
to hold it in place.
NOTE: Once the glue is applied, it will not be possible to change the alignment of the
light pipes without damaging the plastic enclosure.
Notched
side
Light pipe
flange is firmly
against
enclosure