www.youfibercable.com
Email:[email protected] MSN:[email protected]
30
(1) Do the same steps as in section 7.6.1: (1), (2), (3), (4), (5),
(6), (7).
(2) Close the shield and the splicer will exercise Clean, Gap,
Align, Fusion and Tension Test functions automatically.
The result will be displayed on the screen as Figure 7-7
and Figure 7-8.
Notes
：
1. Auto splicing mode is convenient, so we advise the user to
take the auto splicing mode.
2. The splicer has the checking function of fiber cutting angle
and fiber end face, when it works in Semi-auto or auto splicing
mode. The quality of fiber end and face has enormous impact
on the loss of the contacting point; so efforts should be mad as
possible to make the end face plane, and the angle of the place
with the fiber cross-sectional plane should be less than 1
◦
.
7.7 Estimated Splice Loss
Splice loss could be estimated by observing the splicing
operation and the video of the spliced part. If spliced part is
abnormal (the diameter is bigger or smaller or etc.), the fiber
should be re-spliced.
Note: When splicing different fibers or multi fiber, a black
line sometimes appears on the spliced part. But it does not
affect the splice result.
