The frequency reference (voltage) is valid when constant
b1-01
has been set to 1.
Multi-function Analog Input
:
H3
Multi-function Analog Input
:
H3
A 10 V (20 mA) input indicates a frequency reference that
is100% of the max. output frequency
.
SettingRange
SettingRange
Function
Function
Description of choice
Description of choice
SettingRange
SettingRange
Function
Function
Description of choice
Description of choice
Signal level selection
(terminal 1
3)
Refer to the following adjustment of analog input
Refer to the following adjustment of analog input
SettingRange
SettingRange
Function
Function
Description of choice
Description of choice
Sets the frequency when 0 V is inputas a percentage of
the maxi
put,maximum
frequency.
SettingRange
SettingRange
Function
Function
Description of choice
Description of choice
Set the signal level for the multi-function analog input.
Description of settings
Setting
Setting
Function
Function
0 to 10 VDC input [11-bit + polarity (positive/
negative) input]
−10 to 10 VDC input(A negative voltage is a
reference for reverse rotation.)
SettingRange
SettingRange
Function
Function
Description of choice
Description of choice
Multi-function analog
input (terminal 16)
The analog input signal level, gain, and bias are set
with the following constants.When a voltage input is
being input to terminal 14, be sure to disconnect jumper
wire J1 on the controlPC board.
Set the time constant in constant H3-12 when adding a primary delay
filter to an analog input. Thisfilter time constant applies to all three of
the analog inputs.Settings 2 and D cannot be set at the same time. OPE0
7 will be detected.
Terminal 16 signal level
selector
Terminal 16 input gain
Terminal 16 input bias
Terminal 14 signal level
selector
Terminal 14 input gain
Terminal 14 input bias
H3-04 (0 to +10 V or 0 to ±10 V)
H3-06
H3-07
H3-08 (0 to +10 V, 0 to ±10 V,
or 4 to 20 mA)
H3-10
H3-11
Is a registered trademark of yolico
YD3000N
نوﯾﺳﺎﻣوﺗا
ﯽﺗﻌﻧﺻ
ﮏﯾرﺗﮑﻟاوﺑار
قرﺑ
و
