YOKOGAWA UTAdvanced UT55A, User Manual

Page: 420 / 476

18-9
IM 05P01C31-01EN
Parameters
18
SELECT Parameter Menu (Menu: CS)
Parameter
symbol
Name
Display
level
Setting range Initial value
CS10 to
CS19
SELECT parameter
10 to 19
EASY
Setting range of a registered
parameter.
-
SP and Alarm Setpoint Setting Menu (Menu: SP)
Parameter
symbol
Name
Display
level
Setting range Initial value
SP Target setpoint EASY
0.0 to 100.0% of PV input range
(EU) (Setting range: SPL to SPH) SPL
SUB
Sub-target setpoint
(in Two-position
two-level control)
EASY
Set the offset from SP.
-100.0 to 100.0% of PV input range
span (EUS)
0.0 % of PV
input range
span
PIDN
PID number
selection
EASY
1 to 8 (Depends on the PIDG.
setting.)
Same as SP
number.
A1 to A8
Alarm-1 to -8
setpoint
EASY
Set a display value of setpoint of
PV alarm, SP alarm, deviation
alarm, output alarm, or velocity
alarm.
-19999 to 30000 (Set a value
within the input range.)
Decimal point position depends on
the input type.
0
In Cascade control, the following parameters are also displayed for secondary loop. (the LP2 lamp
is lit)
• Parameter: SP, SUB, PIDN, A1 to A8
SP-related Setting Menu (Menu: SPS)
Parameter
symbol
Name
Display
level
Setting range Initial value
RMS
Remote input
method
STD
RSP: Via remote (aux. analog)
input
COM: Via communication
RSP
RFL Remote input filter STD OFF, 1 to 120 s OFF
RT Remote input ratio STD 0.001 to 9.999 1.000
RBS Remote input bias STD
-100.0 to 100.0% of PV input range
span (EUS)
0.0 % of PV
input range
span
UPR SP ramp-up rate EASY
OFF, 0.0 + 1 digit to 100.0% of PV
input range span (EUS)
OFF
DNR SP ramp-down rate EASY OFF
TMU
SP ramp-rate time
unit
EASY
HOUR: Ramp-up rate or ramp-
down rate per hour
MIN: Ramp-up rate or ramp-down
rate per minute
HOUR
SPT
SP tracking
selection
STD OFF, ON ON
PVT
PV tracking
selection
STD OFF, ON OFF
In Cascade control, the following parameters are also displayed for secondary loop. (the LP2 lamp
is lit)
• Parameter: RMS, RFL, RT, RBS, UPR, DNR, TMU, SPT, PVT
18.2 List of Parameters