6-8
IM 04P03B01-01E
Explanation
Hysteresis (
):
Center of the chart paper
Zero position (
): Left edge of the chart paper
Full position (
): Right edge of the chart paper
Hysteresis Adjustment
Adjustment: –7 to 7
A single line is drawn on the chart paper. If the line appears as shown in Figure a,
increase the displayed setting. If the line appears as shown in Figure b, decrease the
displayed setting.
Repeat this procedure until the line becomes straight.
A value change of 1 corresponds to 0.1 mm change in the dot printing position.
Up
Down
Down
Up
Figure a
Figure b
Zero Position and Span Adjustment
Adjustment
Zero position: 00 to 15, full position: –45 to 15
A value change of 1 corresponds to 0.1mm change in the dot printing position.
Decreasing the value moves the line to the left and increasing the value moves the line
to the right.
Note
The procedure is different when the customized menu is enabled.
•
When “P-ADJ” of the customized menu is ON
Carry out steps 1 to 4 in “Adjusting the Dot Printing Position.”
Select “FREE” and press the
key to display “P-ADJ.”
Carry out the steps beginning with 5 in “Adjusting the Dot Printing Position.”
•
When “P-ADJ” of the customized menu is OFF
See “Releasing the Customized Menu” or “Changing the Settings without Releasing the
Basic Setting Mode Lock.”
<Related Topics>
Releasing the customized menu: Section 4.21
Changing the settings without releasing the basic setting mode lock:
Section 4.21
6.5 Adjusting the Dot Printing Position (Dot Model)
