4-42
IM 04L51B01-41EN
4.7 Configuring the Coordinator Module (Low-speed
moving body)
This section explains the configuration of a coordinator module when routers are used in a
low-speed moving state. When using routers in fixed locations, see section 4.5, “Configuring
the Coordinator Module.”
4.7.1
Setup Procedure
Configure the coordinator module by following the procedure below.
…
…
A step that needs to be performed
…
A step that is performed when the condition written on the
right side applies
See “Coordinator Configuration Selection Window,” “Coordinator
Configuration Window,” “Connecting to a Wireless Communication
Coordinator Module”
…
Set terminal information of the wireless communication module.
See “Basic Configuration Tab”
…
Configure serial communication.
See “Communication Setup Tab”
…
Configure the interface.
See “Protocol Setup Tab”
…
When Station number analysis on the Protocol setup tab is set to Yes:
See “Station Number Setup Tab”
…
When Specification method of Station numbers on the Station number
setup tab is set to List: See “Station Number List Window (sub window)”
…
When MAC address authentication on the Basic configuration tab is set
to Yes: See “MAC Address List Window (sub window)”
…
When saving the configuration file
See “Saving the configuration file (Save Configuration button)”
…
Set the network scale.
See “Network Scale Setup Tab”
Step name
Step name
Main window
Connect the coordinator module.
On the Basic configuration tab, enter the
terminal information of the wireless
communication module
On the Station number setup tab, enter
the specification method of station
numbers for the sensors connected to
routers.
Save the configuration file.
Restart the wireless device.
End configuration
Enter the combinations of router short
addresses and station numbers of sensors
connected to the routers.
On the Communication setup tab, enter
the serial interface information between
the wireless communication module and
connected devices.
On the Protocol setup tab, enter the
protocol information used between the
wireless communication module and
connected devices.
In the MAC address list window, enter
the wireless devices to allow connection
to the coordinator module and wireless
devices to refuse.
Optimize the control signal transmission
frequency of the wireless communication
module according to the network scale.
