YOKOGAWA F3LP32-0N, User Manual

Page: 40 / 104

3-4
IM 34M06H43-02E 2nd Edition : Sep.30, 2019-00
3.3 Setting Station Numbers
This sets the station number, which identifies a FA Link module.
Set the station number of the FA Link module using the two 10-position rotary
switches on the front of the module(see Figure 3.3.1). Insert a flat-blade
screwdriver into the slot of the arrow and change the direction of the arrow to
perform setting.
The station number set at power-on is applied to the module. Station numbers
can be set to any arbitrary number in the range from 01 to 32 provided that
station numbers are not duplicated. Do not set to 00 or 33 to 99. Otherwise,
normal operation is not assured. A station with number 01 must be defined
and will be the master station. Station numbers need not be sequential.
The default factory setting is 01.
Note
- If a station number is duplicated but falls within the range from 02 to 32, the
error will not be detected nor indicated by the display LED or the special relay.
(If station number 01 is duplicated or a duplicate station number falls within the
range from 33 to 99, it will be detected and indicated by the display LED and
special relay).
- Any duplicate station number falling within the range from 02 to 32 will prevent
the link data of the entire system to be properly updated. For details, see“ ■
Checking Link Data Allocation” in Chapter 5, “Cautions on Using”.
0
0
LP32-0N FALINK
LNK
STATION NO.
0
0
The above example setting is 01.
Station number setting switch
(2 decimal rotary switches)
Figure 3.3.1 Station Number Setting Switch