YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
YMGI: Your Modern Green Idea
83
5. Take out the condenser.
Loosen the securing screws of
condenser support. Take off the
plate type heat exchanger and the
support as a whole.
6. Install the new condenser.
Secure the screws of condenser
and support. Then fix them
together on the chassis.
Install the condenser by referring
to the positions of entering and
leaving pipes. Weld the
connection pipes.
Nitrogen welding: the pressure of
nitrogen is 0.5±0.1kgf/ cm²
(relative pressure).
NOTE
: When welding the pipes,
do not let the flame burn the other
components.
7. Secure the electric box and
arrange the wires according to
the requirement.
Put the electric box in place and
tighten up the screws of electric
box.
Arrange and secure the wires as
original.
8. Check and open the upper and
side panels.
Check whether each component
and connection wire is well
connected.
If everything is OK, place back
the upper, left and right side
panels.
