YG125-25 Maintenance Manual Overview
13. specified position on the frame.
14. The clamp shall reliably bite the wire harness
In case of a welded clamp, it shall not bite the wire
harness towards the weld mark
The wire harness shall be clamped at the position
without contacting a rotating part or a removing element.
The wire harness shall be clamped at the position
without contacting a part that generates high
temperature.
The wire harness shall be clamped at the position
without contacting the edge or sharp corners of the
vehicle body.
The wire harness shall be incapable of passing through
the position contacting a bolt, a screw head or any front
part.
The wire harness shall not be slackened or be forcibly
pulled.
If the wire harness has to contact the edge or sharp
corner parts, the contacting part shall be protected with
hose or adhesive tape.
In case of a wire harness with garland, it shall be reliably
harnessed.
Do not damage the garnish of the wire harness.
Once the wire harness is damaged, repair it by coiling
with plastic adhesive tape.
While mounting parts and components, do not press the
wire harness.
Do not mount wire harness with it twisted.
Do not touch!
Pay attention not to press it.
6
Summary of Contents for YG125-25
Page 98: ...YG125 25 Maintenance Manual Frame and exhaust system 10 Frame and exhaust system 102...
Page 130: ...YG125 25 Maintenance Manual Illumination signal system Circuit schematic drawing 134...
Page 144: ...YG125 25 Maintenance Manual Electrical System Diagram 19 Electrical System Diagram 148...