YG125-25 Maintenance Manual Magneto and starting system
2.
Remove the starting motor connecting bolt M6×25.
3.
Push the motor towards the right and lift it, and then
carefully take it out from the left side.
Installation is in the reverse order of removal
To mount the rotor assembly:
1.
Mount the disk gear washer, coat the mixture of
engine oil and molybdenum disulfide onto the left
crank journal, and mount the disk gear and confirm
the semicircular key.
2.
Mount the rotor assembly
3.
Mount the plain washer and apply thread retaining
adhesive LOCTITE648 to the fastening nut M12; use
the rotor fastening tool to fasten the rotor,
and screw up the nut M12 to the torque of 45N.m
4.
To install the double-linked gear:
The Washer and the double-linked gear is assembled into
the left crankcase
5.
To install the left front cover:
⑴
Clean the sealing paper gasket remaining on the left
crankcase and left front cover, replace with new left front
cover sealing paper gasket and confirm the location pin,
starting idle gear, double-linked gear, etc. are in correct
position.
⑵
Mount the left front cover,
⑶
Mount the left front cover bolt
⑷
Connect the magneto leads.
⑸
Mount the left rear cover, gear shift pedal and engine
protection plate.
⑹
Put on the oil drain plug and refill engine lubricating oil.
Motor connecting bolt
Torque
Rotor fastening to
o
Apply the mixture of engine oil and
molybdenum disulfide
Double-linked gear
Left front cover
83
Summary of Contents for YG125-25
Page 98: ...YG125 25 Maintenance Manual Frame and exhaust system 10 Frame and exhaust system 102...
Page 130: ...YG125 25 Maintenance Manual Illumination signal system Circuit schematic drawing 134...
Page 144: ...YG125 25 Maintenance Manual Electrical System Diagram 19 Electrical System Diagram 148...
