34
4- Safety
4.1- Intended Use
The gearbox is designed for usage in industrial machines. Please refer to our catalogue or
our web page for the maximum permitted torques and speeds. The most important maxi-
mum permitted values are indicated on the nameplate of the product, but the whole data
can be found on our product catalogues. Using the product out of the product catalogue/
nameplate’s permitted ranges will cancel the warranty / manufacturer declaration and
YILMAZ will not take any responsibility.
The gear units are intended to use for industrial machines and may only be used in ac-
cordance with the information provided in this manual the product catalogue and the
nameplate of the gearbox. They comply with the applicable standards and regulations
and meet the requirements of the directive 2006/42/EC. The gearbox must be started up,
maintained and operated according to this manual. The gearbox must be incorporated with
2006/42/EC confirming parts/machines.
A motor connected to the gear unit is only allowed to be operated in the frequency entries
so that the data provided on nameplate/catalogue of the gearbox is not exceeded and is
accordance with the nameplate/catalogue. The speed range will be provided on the name
plate if YILMAZ REDUKTOR is informed that the gear unit will be used with frequency
inverter. If not informed, the nameplate will have a single fixed speed and only this speed
is allowed.
The electric motor and frequency inverter must be in accordance with 2006/42/EC
If the gear units input is used with variable speed gear unit, YILMAZ must be informed
before ordering and on the nameplate the allowed maximum and minimum speeds (speed
range) will be provided. If not mentioned while ordering, the gearbox’s speed will be a fixed
single input speed and only this speed is allowed.
If the gear unit will be driven by belt / coupling / chain drive etc. the gearbox is only allowed
to used according the nameplate/catalogue entries. Different speed, higher motor power,
higher radial/axial loads etc. than nameplate/catalogue is not allowed.
The ambient temperature must be b5 , +40 celsius and no corrosive media must
attack the paint and seals. If there is different working conditions YILMAZ must be
informed before ordering.
The gearbox maintenance (oil change / check ) must be done according to this manual
4.2- Improper Use
Every usage which exceeds the limits stated above, the nameplate and catalogue of the
product (especially higher torques and speeds) is not compliant with the regulations, and
thus prohibited.
The operation of the gearbox is prohibited if;
-It was not mounted/installed according to regulations and this manual
-The gearbox is very dirty and soiled
-It is operated without lubricant
-It is operated out of the permitted values provided on catalogues and/or nameplate.
Operating Instructions
H Series
YILMAZ REDÜKTÖR
Safety
