Yealink T48G, Administrator'S Manual

Page: 375 / 622

Call Features
355
call when DND is activated. You can specify a priority that the incoming paging calls with higher or equal
priority are automatically answered, and the lower ones are ignored.
If it is disabled, all the incoming paging calls will be ignored when DND is activated in phone mode.
Topic
Multicast Paging Settings
Multicast Paging Settings Configuration
The following table lists the parameters you can use to change multicast paging settings.
Parameter multicast.codec <y0000000000xx>.cfg
Description
It configures the codec for multicast paging.
Example:
multicast.codec = G722
Note: It is not applicable to T19(P) E2 IP phones.
Permitted
Values
PCMU, PCMA, G729, G722
Default G722
Web UI Features->General Information->Multicast Codec
Parameter multicast.receive_priority.enable <y0000000000xx>.cfg
Description
It enables or disables the IP phone to handle the incoming multicast paging calls
when there is an active multicast paging call on the IP phone.
Permitted
Values
0-Disabled, the IP phone will ignore the incoming multicast paging calls when there is
an active multicast paging call on the IP phone.
1-Enabled, the IP phone will receive the incoming multicast paging call with a higher
priority and ignore the one with a lower priority.
Default 1
Web UI Directory->Multicast IP->Paging Priority Active
Parameter multicast.receive_priority.priority <y0000000000xx>.cfg
Description
It configures the priority of the voice call (a normal phone call rather than a multicast
paging call) in progress.
1 is the highest priority, 31 is the lowest priority.
Permitted
Values
0-Disabled, all incoming multicast paging calls will be automatically ignored when a
voice call is in progress.
1-1
2-2