Yealink T48G, Administrator'S Manual

Page: 306 / 622

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
286
10 seconds and then dials out 15 if no numbers entered;
When you enter 153, it also matches part of two digit maps, the IP phone tries to wait
10 seconds. But after waiting for 5 seconds, it completely matches the first digit map
and then immediately dials out 153.
Note: It works only if “dialplan.digitmap.enable” or
“account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by the
parameter “account.X.dialplan.digitmap.interdigit_long_timer” takes precedence over
that configured by this parameter.
Permitted
Values
Integer from 0 to 255
Default 10
Parameter dialplan.digitmap.interdigit_short_timer <y0000000000xx>.cfg
Description
It configures the timeout interval (in seconds) for any string of digit map.
The IP phone will wait this many seconds before matching the entered digits to the
dial plan and placing the call.
Note: It works only if “dialplan.digitmap.enable” or
“account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by the
parameter “account.X.dialplan.digitmap.interdigit_short_timer” takes precedence over
that configured by this parameter.
Permitted
Values
Single configuration (configure a specific value for the timer letter “T” for all strings
with “T” of the digit map)
Example:
dialplan.digitmap.interdigit_short_timer = 5
If “dialplan.digitmap.string” is set to <[2-9]x:86>3.T|0T, the IP phone will wait 5
seconds before matching the entered digits to this dial plan and placing the call.
Distribution configuration (configure a string of positive integers separated by “|”
for each string of the digit map in the corresponding position)
If there are more digit maps than timeout values, the last timeout is applied to the
extra digit map. If there are more timeout values than digit maps, the extra timeout
values are ignored.
Example:
dialplan.digitmap.interdigit_short_timer = 4|5|3|6|2|1
If “dialplan.digitmap.string” is set to <[2-9]x:86>3.T|2T|1xxT|0x.!|[2-9]11T, 4 is applied
to the “<[2-9]x:86>3.T” digit map, 5 is applied to “2T” digit map, 3 is applied to “1xxT”
digit map, 6 is applied to “0x.!” digit map, 2 is applied to the “[2-9]11T” digit map, the
last digit 1 is ignored.
Default 3
Parameter dialplan.digitmap.no_match_action <y0000000000xx>.cfg