Yanmar 2TNV70, Operation Manual

Page: 95 / 142

PERIODIC MAINTENANCE
TNV Operation Manual 77
8. Dispose of used oil properly.
Remove the engine oil filter as follows:
1. Turn the engine oil filter (Figure 2, (2))
counterclockwise (Figure 2, (3)) using a filter
wrench.
Figure 2
2. Clean the engine oil filter mounting face.
3. Lightly coat the gasket on the new oil filter
with engine oil. Install the new engine oil filter
manually by turning it clockwise
(Figure 2, (4)) until it contacts the mounting
surface. Tighten an additional 3/4 of a turn
using the filter wrench.
4. Add new engine oil to the engine through
either of the oil filler ports as specified in
Adding Engine Oil on page 39 .
5. Warm up the engine by running it for 5
minutes and check for any engine oil leaks.
6. After engine is warm, shut it off and let it sit for
10 minutes.
0000651A
(3)
(4)
(2)
(1)
0000062A
(3)
(4)
(2)
(1)
Applicable Engine Oil Filter Part No.
2TNV70, 3TNV70, 3TNV76 119305-35150
Applicable Engine Oil Filter Part No.
3TNV82A, 3TNV84,
3TNV84T, 3TNV88,
4TNV84, 4TNV84T,
4TNV88, 4TNV94L,
4TNV98, 4TNV98T
129150-35152
4TNV106, 4TNV106T 119005-35100
CAUTION
0000015en
• NEVER overfill the engine with engine
oil.
• ALWAYS keep the oil level between
upper and lower lines on the dipstick.