Yamato DP-6700, Technical Manual

Page: 16 / 55

YCO-201008
DP-6700 Technical Manual
- operation for parameter value:
Press the key to decrement the parameter value by
1 ( or increment it by -1)
Keeping the key down for a while automatically
decrements the parameter value by 1 continuously.
If the current setup value is 0, the maximum value ap-
pers.
+10 operation for parameter value:
Press the key while holding down the key to
increment the parameter value by 10.
If the settings range of the parameter is less than 10.
"000" stays on the panel in spite of the operation.
-10 operation for parameter value:
Press the key while holding down the key to
decrement the parameter value by 10 (or increment it by
-10).
If the setting range of the parameter is less than 10,
the maximum setup limit for the parameter stays on the
panel in spite of the operation.
Returning to test mode:
Press the key while holding down the key, and
it returns to test mode.
Note: Turn off the power and restart to make changes
effective.
(3) Factory Parameter Mode (to set increment, area, default values and others)
Related pages: Page 1-5 1.3.1 How to enter test mode and meanings of panel indications
Page
1-22 1.3.6 Span adjustment (calibraton)
System parameter mode is used to change the parameters that determine the specifications of the scale.
The following parameters from 40 to B8 can be set, confirmed and changed. To switch to system
parameter mode, you must switch to test mode first. See 1.3.1 How to enter test mode and
meanings of panel indications
on Page
1-5
for switching to test mode. When you replace the CPU
board make sure to check the correctness of the parameters, referring to the parameters table.
1-13
Chapter 1 Adjustment method