Yamato DP-6700, Technical Manual, Page: 13 / 55

YCO-201008
DP-6700 Technical Manual
How to Set User Parameters
Prodcedure Indication
How to switch to User Parameter Mode:
There are the following two ways to switch to user parameter mode:
In normal mode, press the key
while holding down the key; and switches to user param-
eter mode.
The user parameters can also be set in dealer parameter
mode that will be described later
See (2) System Parameter Mode (to set stability detection and oth-
ers) on Page 1-10 for how to set the dealer parameters.
Going to the next parameter:
Press key to go to the next parameter.
To change the setup vaue, enter a new value and go to the next
parameter.
Make sure to go to the next parameter to enable the new value.
If you exit before moving to the next parameter, the system dis-
cards the entered value.
Going back to the previous parameter:
To go back to the previous parameter, press the key while
holding down the key.
+1 operation for parameter value:
Press the key to increment the parameter value by 1.
If the value exceeds the setting range, the value returns to 0
-1 operation for parameter value:
Press the key to decrement the parameter value by 1 (or
increment it by -1)
If the current setup is 0, the maximum value appears.
1-10
Chapter 1 Adjustment method