Cod. 94507
11
TECHINCAL DATA
Model
AC-100
Code
94507
Tension
230V-50Hz
Protection
II
Power
180W
Speed R.P.M.
6300
Disc size
100x3,2mm
vibration: weighted acceleration
m/s
2
. K=1,5
3,21
sound power level dB (A).
96 dB(A)
Noise/Vibration Information
Measured values determined according to EN 60745.
Uncertainty K=3 dB.
Wear hearing protection!
The typically weighted acceleration is on the above table.
The vibration emission level given in this information sheet has been measured in
accordance with a standardised test given in EN 60745 and may be used to compare
one tool with another. The vibration emission level will vary because of the ways in which a
power tool can be used and may increase above the level given in this information sheet.
Note: To be accurate, an estimation of the level of exposure to vibration experienced
during a given period of work should also take into account the times when the tool is
switched off and when it is running but not actually doing the job. This may significantly
reduce the exposure level over the total working period.
Intended Use
The machine is intended for use for sharpening the chains of chainsaws used both by
professionals and DIY sector. The machine is intended for use by a single operator
standing beside it who carries out all the operations necessary for its use.
When using electric tools it is imperative to take the following basic safety precautions in
order to reduce the risk of electric shock, injury and fire. Read and take note of these
instructions before you use this tool.
GENERAL SAFETY REGULATION
Read this manual carefully before operation to avoid the hazards such as
electric shock, burn of fire.
•
The work area must be kept clean to avoid danger.
•
Pay attention to the environment, do not expose the tool in rain or humid place. Keep
work area lit up. Don’t use the tool in presence of inflammable liquid or gas.
•
Pay attention to do not touch the grounding parts, pipes, heat elements, so that to
avoid electric shock.
•
Take care of the tool. Put it in dry place when not in use, and far from children.
•
Don’t overload the tool. Operate only within the load level suggested.
•
Dress properly : Don’t wear loose clothing or jewelry because they can be caught in
moving parts. Rubber gloves and non-skid footwear are recommended when working.
Wear protective hair covering to contain long hair.
•
Use safety glasses and dust musk if operation is dirty.
Summary of Contents for AC-100
Page 2: ...2 ...
