14
En
Initial Setup
6
Check whether the TV turned on and off
correctly.
y
• To cancel the TV Remote Code Test procedure, press
BACK
.
• If the TV turns off during the test and does not turn back
on after waiting over a minute, turn the TV on using the
TV’s remote control.
7
When the following message appears, select
“Yes” or “No - Try next code”.
Select “Yes” to finish the TV Remote Code Test
procedure or “No - Try next code” to check another
remote control code. When you select “No - Try next
code”, the test mode of the other code starts
immediately.
This unit does not contain all possible codes for
commercially available TVs. If this unit does not turn the
TV off/on with the codes provided for that brand, select
“Learn Code” to recall the TV Remote Code Learning
screen (
☞
P. 42) and program the remote control code
manually.
8
Select “Save” to finish the TV remote control
code setting and proceed with the Initial
Setup process.
y
When you want to set the TV remote control code again,
select “Change Code”.
y
Prepare the
Connection Planning Chart of the Quick Setup
Guide in advance.
In these instructions, the examples assume that the
connections below are made.
Note
Step 3: Source Device Setup
A
pt
15 pt
9 pt
3 pt
3 pt
2 pt
1 pt
Device 1
Cable box
CB-528
Time W
15
01EN_00_YMC-700_500_U.book Page 14 Wednesday, April 8, 2009 11:46 AM
