Yamaha WR250F 2022, Owner'S Service Manual, Page: 75 / 404

CABLE ROUTING DIAGRAM
2-22
1. Clutch cable
2. Clutch switch lead
3. Engine stop switch lead
4. Front brake hose
5. Headlight lead
6. Multi-function display coupler
7. Speed sensor coupler
8. Start switch lead
9. Plastic locking tie
10.Speed sensor lead
11.Throttle cable
12.Multi-function display
A. Pass the throttle cable, clutch cable, clutch
switch lead, engine stop switch lead, start
switch lead and speed sensor lead between
the wire guide of the meter bracket and the
handle crown (in no particular order).
B. Pass the engine stop switch lead between the
frame and the cable guide.
C. Fasten the main harness, clutch switch lead,
start switch lead and speed sensor lead to
the meter bracket using the plastic locking tie.
When fastening, turn the steering to left and
no slack. The speed sensor lead should be
fastened at the gray tape. Face the end of the
plastic locking tie to the right side of the vehi-
cle. The excess should be cut.
D. Connect the headlight lead to the headlight.
E. After fastening the speed sensor lead, route it
as U-letter and route along the start switch
lead. Pass it through the bottom of the front
brake hose.
F. Fasten the start switch lead to the handlebar
using the plastic locking tie. Do not cut the
end of the plastic locking tie.
G. Vertical direction of vehicle
H. 70–110

I. Fasten the paint portion of the speed sensor
lead at the shrinking tube of the front brake
hose.
J. Fasten at the paint portion of the speed sen-
sor lead. The place of the front brake hose
does not matter.
K. Fasten the start switch lead and speed sen-
sor lead to the handlebar using the plastic
locking tie. Do not cut the end of the plastic
locking tie.
L. Fasten at the center of both sides of the
clamps.
M. Fasten the engine stop switch lead and the
clutch switch lead to the handlebar using the
plastic locking tie. Do not cut the end of the
plastic locking tie.
N. 30–50
