Yamaha MBK X-MAX 300 2017, Service Manual

Page: 176 / 462

HANDLEBAR
4-77
b. Slide the handlebar grip over the left end
of the handlebar.
TIP
Make sure that the distance “a” between the end
of the left handlebar switch and the end of the
handlebar grip is 0 mm (0 in).
c. Wipe off any excess rubber adhesive with
a clean rag.
WARNING
EWA13700
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
d. Install the left grip end.
TIP
There should be 1.0–5.0 mm (0.04–0.20 in) of
clearance “a” between the handlebar grip and
the grip end.
EAS32356
INSTALLING THE UPPER HANDLEBAR
COVER
1. Install:
• Upper handlebar cover “1”
• Upper handlebar panel “2”
a. Fit the projections “a” on the upper handle-
bar cover into the holes “b” in the lower
handlebar cover.
TIP
There should be 0.5–4.0 mm (0.02–0.16 in) of
clearance “c” between the upper handlebar cov-
er and handlebar switch.
b. Install the quick fasteners and upper han-
dlebar cover screws, and then tighten the
screws to specification.
T
R
.
.
Grip end bolt (left)
7 N·m (0.7 kgf·m, 5.2 lb·ft)
a
1
a
2
T
R
.
.
Upper handlebar cover screw
1.8 N·m (0.18 kgf·m, 1.3 lb·ft)
1
a
b
c c
1
2