Yamaha FJR1300A(X), Service Manual

Page: 273 / 754

FRONT FORK
4-86
14.Measure:
• Front fork leg oil level “a”
(from the top of the inner tube, with the outer
tube fully compressed and without the fork
spring)
Out of specification
→
Correct.
NOTE:
• While filling the front fork leg, keep it upright.
• After filling, slowly pump the front fork leg up
and down to distribute the fork oil.
15.Install:
• Fork spring
NOTE:
Install the fork spring so that the end “A” shown
in the illustration is facing up.
16.Install:
• Nut “1”
• Damper adjusting rod “2”
• Cap bolt “3”
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Install the nut “1” and finger tighten it.
b. Install the damper adjusting rod “2”.
c. Install the cap bolt “3” and finger tighten it.
WARNING
EWA13670
Always use a new cap bolt O-ring.
d. Hold the cap bolt and tighten the nut “1” to
specification.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
17.Install:
• Cap bolt
(to the outer tube)
NOTE:
Temporarily tighten the cap bolt.
EAS23050
INSTALLING THE FRONT FORK LEGS
The following procedure applies to both of the
front fork legs.
1. Install:
• Front fork leg
Temporarily tighten the upper and lower
bracket pinch bolts.
NOTE:
Make sure the inner tube is flush with the top of
the upper bracket.
2. Tighten:
• Lower bracket pinch bolts “1”
• Cap bolt “2”
Level
92.0 mm (3.62 in)
a
A
T
R
.
.
Nut
25 Nm (2.5 m·kg, 18 ft·lb)
T
R
.
.
Lower bracket pinch bolt
23 Nm (2.3 m·kg, 17 ft·lb)
T
R
.
.
Cap bolt
25 Nm (2.5 m·kg, 18 ft·lb)