Yamaha FJR1300A(X), Service Manual

Page: 679 / 754

YCC-S (Yamaha Chip Controlled-Shift) SYSTEM (FJR1300AS
only)
8-202
ET3P66065
TROUBLESHOOTING DETAILS
This section describes the measures per fault code number displayed on the meter. Select diagnostic
code No. Sh_ _61, and then confirm the fault code numbers in the malfunction history. Check and ser-
vice the items or components that are the probable cause of the malfunction following the order given.
After the check and service of the malfunctioning part has been completed, reset the meter display ac-
cording to the reinstatement method. Then select diagnostic code No. Sh_ _62 in the diagnostic mode
to erase the malfunction history.
Fault code No.:
Code number displayed on the meter when the engine failed to work normally. Refer to “Self-Diagnostic
Function table”.
Sh_ _66 Adjust the clutch en-
gagement position
Sh_ _66 This mode adjust the clutch engagement
point manually.
The clutch engagement point while the ve-
hicle is starting off can be adjusted manu-
ally to 21 engine speed settings in this
mode. The initial setting of the clutch en-
gagement point varies according to the ve-
hicle.
• Hand shift lever switch operation (shift
up)
To increase the clutch engagement point
by approximately 100–150 r/min, oper-
ate the hand shift lever switch (shift up)
four times. After the switch is operated,
the hand shift select indicator light will
come on for 0.6 second.
• Hand shift lever switch operation (shift
down)
To decrease the clutch engagement point
by approximately 100–150 r/min, oper-
ate the hand shift lever switch (shift
down) four times. After the switch is oper-
ated, the hand shift select indicator light
will come on for 0.3 second.
To write the changed setting on EE-
PROM, push the hand shift select button
for 0.3 second. After the button is
pushed, the hand shift select indicator
light will come on for 2 seconds.
Diagnos-
tic code
No.
Item
Data displayed on
meter (reference
value)
Checking method