4. If the carburetors were not separated, disconnect
the carburetor heater wires by performing Steps 1-4
in
Separation
in this section.
5. Remove the top cover as follows:
a. Remove the top cover screws (A,
Figure 41
).
b. When servicing the rear carburetor, remove
the choke cable bracket (B,
Figure 41
) from
the top cover.
c. Watch for the collar (
Figure 42
) beneath the
outboard screw on the rear carburetor.
d. Remove the top cover (C,
Figure 41
) from
the carburetor.
6. Remove the spring (A,
Figure 43
) and vacuum
piston (B).
7. Remove and discard the small O-ring (A,
Figure
44
).
8. Remove the needle retainer (
Figure 45
) from the
vacuum piston and remove the jet needle (
Figure
46
).
9. Remove pilot air jet No. 2 (B,
Figure 44
) from
the vacuum piston bore.
10. Remove pilot air jet No. 1 (
Figure 47
) from the
carburetor intake horn.
216
CHAPTER EIGHT
39
40
41
42
43
44