CVP-409/407 Owner’s Manual
211
Appendix
2
Attach two front legs and a rear leg.
Refer to the diagram below to verify the orientation
of the legs.
Install and tighten four 6 x 40 mm screws on each
leg, starting with one of the front legs.
3
Install the pedal box.
1
Remove the twist tie that affixes the pedal cord to
the upper portion of the pedal box.
2
Align the cord with the groove on the unit, and
attach the pedal box using four 6 x 20 mm
screws.
3
Insert the pedal cord plug into the pedal
connector. Insert the plug so the arrow side faces
front (toward the keyboard).
If the plug will not go in easily, do not force it.
Double-check the orientation of the plug, then try
again.
4
Attach the cord holder on the unit as shown in the
illustration below, then use the cord holder to
affix the pedal cord.
4
Raising the unit to the standing position.
Use the front legs as support to raise the unit.
Rear leg
Front leg
Front leg
Twist tie
CAUTION
• Be careful not to pinch your fingers.
• When you raise the unit, do not hold the key cover.
4
3
