8 - 51
CHAS
REAR KNUCKLE AND STABILIZER
CHECKING THE REAR KNUCKLE
1.Check:
●
Rear knuckle
Damage/pitting
→
Replace.
2.Check:
●
Rear wheel bearings
Bearings allow play in the wheel hubs or the
wheel turns roughly
→
Replace.
●
Oil seals
Damage
→
Replace.
*****************************************************
Replacement steps:
●
Clean the outside of the rear knuckle.
●
Remove the oil seals
1
.
●
Drive out the bearings
2
.
WARNING
Eye protection is recommended when
using striking tools.
●
Remove the spacer
3
.
●
Apply lithium base grease to the bearings
and oil seals.
●
Install the spacer to the rear knuckle.
●
Install the new bearings.
NOTE:
Install the outside bearing first.
CAUTION:
Do not strike the center race or balls of the
bearing. Contact should be made only with
the outer race.
●
Install a new oil seal.
NOTE:
When installing the oil seals, the “seal side” of
the oil seal faces out.
*****************************************************
CHECKING THE STABILIZER
1.Check:
●
Stabilizer
Bends/cracks/damage
→
Replace.
Summary of Contents for 5KM2-AE1
