7 - 23
DRIV
REAR CONSTANT VELOCITY JOINT/FINAL DRIVE GEAR
AND DRIVE SHAFT
REMOVING AND DISASSEMBLING THE
FINAL DRIVE ROLLER BEARING
1.Remove:
●
Roller bearing (ring gear)
1
Use a suitable press tool
2
and an appropri-
ate support for the main housing.
2.Remove:
●
Roller bearing (final drive pinion gear)
1
*****************************************************
Removal steps:
●
Heat the main housing only to 150 °C
(302 °F).
●
Remove the roller bearing outer race with an
appropriately shaped punch
2
.
●
Remove the inner race from the final drive
pinion gear.
NOTE:
The removal of the final drive pinion gear roller
bearing is difficult and seldom necessary.
*****************************************************
3.Install:
●
Roller bearing (final drive pinion gear
)
*****************************************************
Installation steps:
●
Heat the main housing only to 150 °C
(302 °F).
●
Install the roller bearing outer race using the
proper adapter.
●
Install the inner race onto the drive pinion
gear.
*****************************************************
4.Install:
●
Roller bearing
1
Use a suitable press tool
2
and a press to
install the above components into the main
housing.
New
Summary of Contents for 5KM2-AE1
