Yamaha 2016 Grizzly yf700gg, Service Manual

Page: 348 / 474

REAR CONSTANT VELOCITY SHAFT ASSEMBLIES, FINAL
DRIVE ASSEMBLY AND REAR DRIVE SHAFT
8-27
If “-12” is stamped on the outside of the final
driven pinion gear,
“f” = 51.0 - 0.12
= 50.88
If “-05” is stamped on the outside of the final
driven pinion gear,
“g” = 24.0 - 0.05
= 23.95
“h” = 49.8
Therefore, shim and thrust washer thickness
“B” is 5.16.
“B” = 49.8 - (71.57 - 50.88 + 23.95)
= 5.16
Round off the hundredth digit and select the
appropriate shim(s).
In the example above, the calculated number
is 5.16. The chart instructs you to round off 6
to 5 at the hundredth place.
Thus, the shim and thrust washer thickness is
5.15 mm.
Shim and thrust washer are supplied in the
following thicknesses.
TIP
Be sure to use one of each of the final driven pin-
ion gear shim (final drive case side) “1” and
thrust washer “2” to obtain the shim and thrust
washer thickness.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
EBS30411
SELECTING THE FINAL DRIVEN PINION
GEAR SHIM (FINAL DRIVE CASE COVER
SIDE)
1. Measure:
• Final driven pinion gear thrust clearance “C”
Hundredth Rounded value
0, 1, 2 0
e
f
g
3, 4, 5, 6, 7 5
8, 9 10
Final driven pinion gear shims (fi-
nal drive case side) “1”
Thickness (mm)
0.25 0.30 0.35 0.40 0.45 0.50
Thrust washer “2”
Thickness (mm)
4.50 4.80 5.10 5.40
Hundredth Rounded value
C