Yamaha 2016 Grizzly yf700gg, Service Manual

Page: 104 / 474

PERIODIC MAINTENANCE
3-21
6. Measure: (for EPS models)
• Steering tension
Above specification
→
Adjust.
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Set the main switch to “ ” (off).
b. Place the vehicle on a suitable stand so that
the front wheels are elevated.
c. Point the front wheels straight ahead.
d. Hold the belt tension gauge “1” at a 90° angle
to the handlebar, push the gauge against the
handlebar, and then record the measurement
when the handlebar starts to turn.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
7. Adjust: (for EPS models)
• Steering tension
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Remove the electrical components tray.
Refer to “GENERAL CHASSIS (4)” on page
4-11.
b. Loosen the steering stem bracket bolts “1”
and steering stem pinch bolt “2” completely.
TIP
After loosening the bolts, be sure to check that
the steering stem moves smoothly on the serra-
tions of the shaft of the EPS unit.
c. Tighten the steering stem bracket bolts to
specification.
d. Tighten the steering stem pinch bolt to speci-
fication.
e. Measure the steering tension again.
f. Repeat the above procedure until the steer-
ing tension is below specification.
g. Install the electrical components tray. Refer
to “GENERAL CHASSIS (4)” on page 4-11.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
EBS30062
ADJUSTING THE TOE-IN
1. Place the vehicle on a level surface.
2. Measure:
• Toe-in
Out of specification
→
Adjust.
Steering tension
50 N (5.0 kgf)
Belt tension gauge
90890-03170
Rear drive belt tension gauge
YM-03170
1
T
R
.
.
Steering stem bracket bolt
51 Nm (5.1 m·kgf, 37 ft·lbf)
LOCTITE®
T
R
.
.
Steering stem pinch bolt (for EPS
models)
35 Nm (3.5 m·kgf, 25 ft·lbf)
LOCTITE®
Steering tension
50 N (5.0 kgf)
1
2