Yamaha 2016 Grizzly yf700gg, Service Manual, Page: 309 / 474

FUEL TANK
7-2
EBS30221
REMOVING THE FUEL TANK
1. Extract the fuel in the fuel tank through the
fuel tank cap with a pump.
2. Remove:
• Fuel hose connector holder
• Fuel hose
WARNING
EWB03050
Cover fuel hose connections with a cloth
when disconnecting them. Residual pres-
sure in the fuel lines could cause fuel to
spurt out when removing the hose.
NOTICE
ECB01700
• Be sure to disconnect the fuel hose by
hand. Do not forcefully disconnect the
hose with tools.
• Although the fuel has been removed from
the fuel tank, be careful when removing the
fuel hose, since there may be fuel remain-
ing in it.
TIP
• When removing the fuel hose from the fuel
pump, remove the fuel hose connector holder
first, and next, insert a slotted head screwdriver
etc. in the slot part “a” of the fuel hose connec-
tor cover “1”, then slide it in the direction of the
arrow, and remove the fuel hose.
• To remove the fuel hose from the throttle body,
slide the fuel hose connector cover “2” on the
end of the hose in direction of the arrow shown,
press the two buttons “3” on the sides of the
connector, and then remove the hose.
• Before removing the hose, place a few rags in
the area under where it will be removed.
3. Remove:
• Fuel tank
TIP
Do not set the fuel tank down on the installation
surface of the fuel pump. Be sure to lean the fuel
tank in an upright position.
EBS30222
REMOVING THE FUEL PUMP
1. Remove:
• Fuel pump bracket
• Fuel pump
• Fuel pump gasket
NOTICE
ECB01450
• Do not drop the fuel pump or give it a
strong shock.
• Do not touch the base section of the fuel
sender.
EBS30223
CHECKING THE FUEL PUMP BODY
1. Check:
• Fuel pump body
Obstruction
→
Clean.
Cracks/damage
→
Replace the fuel pump
assembly.
EBS30224
CHECKING THE FUEL TANK BREATHER
HOSE JOINT
1. Check:
• Fuel tank breather hose joint
Damage/faulty
→
Replace.
EBS30225
INSTALLING THE FUEL PUMP
1. Install:
• Fuel pump gasket
• Fuel pump
• Fuel pump bracket
T
R
.
.
Fuel pump nut
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
New