Instruction #1035971B - Page 8 of 15
ADJUST LANDING PAD POSITIONS THEN TIGHTEN THEM DOWN.
Using your tower instructions as a reference,
carefully place an assembled crossbar with
towers onto the Landing Pads.
Align position of Landing Pads to allow
SkyLine or Control Towers to fully close.
Center crossbar and fully torque your SkyLine
or Control towers to the crossbars according
to the tower instructions.
Open one SkyLine or Control Tower cover and
lift it up while opposite tower is still engaged.
While holding SkyLine or Control Tower above
Landing Pad, fully tighten Landing Pad with
long handle of wrench as shown to 2.5 Nm.
Repeat the process again for the other Landing
Pads to ensure they have not changed position.
Re-insert SkyLine or Control Tower into the
Landing Pad, fully tighten the tower (refer to
tower instructions) and close the cover.
25
2.5 Nm (22.1 in lb)
READ THESE WARNINGS!
Remove your YAKIMA rack and
accessories before entering
automatic car washes.
To review your vehicle’s specific
weight limit and load limitations for
accessories, visit yakimatech.com.
For additional product support ,
visit yakima.com/support or
contact us directly at (888)925-4621
Monday through Friday, 7:00 AM
to 4:00 PM, PST.
Make sure SkyLine or Control Towers, with bars
installed, seat completely with Landing Pad. If
they do not seat properly, repeat step 25.
Be sure all hardware is secured according to
instructions. Failure to perform safety checks
before driving away can result in property
damage, personal injury, or death.
Attachment hardware can loosen over time.
Check and tighten, if necessary, before each use.
To avoid damage to your vehicle’s finish remove
and clean Landing Pads and mounting points
periodically as road sediment will accumulate
over time.
Landing Pad top must remain installed at all
times to assist in keeping ditch molding in
position.
DO NOT EXCEED
MAXIMUM WEIGHT LIMIT
FOR YOUR VEHICLE.
27
26
INSTALL
COVERS WHEN
RACK IS NOT
ATTACHED.
Using the
covers will help
keep the bases
free of debris.
2X
